Catalog

Black Rating Disc for 6496ALB DOT 406
  • Dual Purpose Vent
  • Roll Over Protection
  • Compact Design
  • Interior Mount
A normal vent designed for use on MC306 & DOT406 cargo tanks. Model 6496 has a pressure setting per 178.346-3(b)(2) of "not less than 1 PSIG" and a vacuum setting per 178.346-3(c)(2) "no more than 6 ounces" which allows for efficient recovery of vapors during closed system loading and offloading. Unique roll over protection retains product at any attitude of rollover. Vent is flow tested and marked.
Unit of Measure

Discount

Unit
Discount Price / %
4   and up
5%

Package Type

N/A Each

Units Per Package

N/A 1

Body Material

N/A Aluminum

Seal Material

N/A Buna

Manufacturer

N/A Betts

Vendor Item #

N/A 6496ALB

Weight

N/A 1 lb

Qty Req'd for Discount

N/A 4

% Discount at Checkout

N/A 5 %

N/A Use only Betts Industries, Inc replacement components. Use of substitute parts can impair the proper function of this product and void all warranties.

N/A Per TTMA Technical Bulletin No. 92 "Inspect pressure relief valves and normal pressure/vacuum valves with sufficient frequency, but no less than once a month, to insure they are operational. Corroded parts must be replaced. Valves that are filled with residue must be cleaned. If venting devices are not operational, do not operate the cargo tank until the venting devices are repaired or replaced. Failure to follow this procedure can result in liquid or vapor leakage and tank damage."

To inspect vent, remove from tank and check for obstructions in the exit port and pressure inlets. Shake vent to ensure roll-over guide block (#5) slides freely up and down. The vacuum disc (#14) is spring-loaded and should open approximately 1/8" to expose vacuum seat when the hex nut (#16) is gripped with a pair of pliers and pulled directly down.

Dirt and residue can be cleaned from the vent by soaking in mild detergent, rinsing with clean water, and blowing out with compressed air.